萃取塔数学模型及过程强化的若干研究进展

萃取塔因生产能力大、占地面积小、密闭性好等优点，在石油、化工、生物、医药和环境工程等多领域被广泛应用。本文从以下几个方面介绍了萃取塔近些年的研究进展：综述了传统萃取塔（脉冲萃取塔、转盘塔与Kühni塔等）的水力学、轴向扩散与传质模型的发展，分析比较了表面张力、传质方向、放大效应等因素对模型的影响；介绍了计算流体动力学（CFD）在萃取塔中单液滴、单相流模拟、液-液两相流模拟、外加能量模拟、与群体平衡模型（PBM）耦合模拟中的应用进展；介绍了国内外设计开发的新型萃取塔，包括改变传统塔的内构件和引入多种外场能量等方式来强化相间传质。研究表明，将先进实验研究方法、准确经验模型和可靠理论计算相结合，将会是萃取塔研究的重要手段和方向。     

便携式飞行时间质谱仪的研制及其在石化污水系统挥发性有机物监测中的应用

近年来，国内的大气污染问题越来越严重，挥发性有机物（VOCs）的排放是其中一个重要原因。VOCs是臭氧和气溶胶的前驱物之一，在大气化学反应过程中扮演着极其重要的角色。本实验自行研制了一台基于真空紫外（VUV）灯的高分辨光电离飞行时间质谱仪（TOF MS），建立了一种新的VOCs稀释采样方法，并将其应用于石化行业污水处理系统VOCs的采样与分析。结果表明：隔油系统的3个池子基本没有测到高浓度的挥发性有机物，其中溶气气浮甲苯物质的质量浓度最高，为50.41 mg/L，其余组分的质量浓度大多数在0.1~1.0 mg/L之间；1#加氢和2#加氢隔油池有着类似的组分浓度，以1#加氢隔油池为例，二甲苯物质的质量浓度为10.60 mg/L，乙苯为52.33 mg/L，苯为59.80 mg/L；由于罐区隔油池没有加盖，处于露天状态，挥发性有机物气体容易向大气中扩散，并没有检测出较高浓度组分。可以看出，新式采样方法可有效地稀释定量样品，操作简便，减少了样品因闪蒸过程造成的VOCs损失，检出物质更丰富；同时，使用自行研制的TOF MS仪器能够快速检测不同装置污水处理系统的VOCs种类，将该仪器用于实际样品检测，发现化工企业大多数密闭的池子都含有苯系物、醚类等，但不同工艺的污水处理系统VOCs存在明显差异。该质谱仪适用于石化企业污水系统VOCs监测。     

Technical and economic analysis of solvent-based lithium-ion electrode drying with water and NMP

Processing lithium-ion battery (LIB) electrode dispersions with water as the solvent during primary drying offers many advantages over N-methylpyrrolidone (NMP). An in-depth analysis of the comparative drying costs of LIB electrodes is discussed for both NMP- and water-based dispersion processing in terms of battery pack $/kWh. Electrode coating manufacturing and capital equipment cost savings are compared for water vs. conventional NMP organic solvent processing. A major finding of this work is that the total electrode manufacturing costs, whether water- or NMP-based, contribute about 8–9% of the total pack cost. However, it was found that up to a 2?×?reduction in electrode processing (drying and solvent recovery) cost can be expected along with a $3–6?M savings in associated plant capital equipment (for a plant producing 100,000 10-kWh Plug-in Hybrid Electric Vehicle (PHEV) batteries) using water as the electrode solvent. This paper shows a different perspective in that the most important benefits of aqueous electrode processing actually revolve around capital equipment savings and environmental stewardship and not processing cost savings.     

Numerical modeling assessment of mechanical effect in bovine leather drying process

Leather manufacturing involves a crucial energy-intensive drying stage in the finishing process to remove its residual moisture and generates important heat gradients. The numerical model presented in this study has been developed to describe the drying process of porous medium: bovine leather that undergoes deformation due to shrinkage. The mathematical formulation of fundamental heat, mass and momentum transfers’ phenomena during drying summarizes a two-dimensional model considering elastic behavior of bovine leather. The evolution of moisture content, temperature, and mechanical stresses during drying was discussed. The model was validated with experimental results. Numerical simulations show good agreement with experimental results. The study shows that the elastic model keeps the stress sign at the final stage of drying. The deformations induce tensional stresses near the surface equilibrated by compressive stresses within the product. They reached their maximum for normal stresses equal to 5.97 and 3.52?MPa at around 2145 and 868?s, respectively, for normal stresses along x and y directions and then decrease.     

建筑工程地基检测技术要点分析及优化对策

针对建筑工程的地基检测技术进行重点分析,并且相应的提出了检测技术的优化对策,以此来促进建筑工程得以顺利发展。     

超高效液相色谱串联质谱法测定烟草中的噁霉灵残留

为降低烟草中噁霉灵检测中的基质干扰，提高检测灵敏度和和稳定性，通过试验建立了以QuEChERS为样品前处理方法、液相色谱串联质谱仪为检测仪器的烟草中噁霉灵残留检测方法。样品加水浸润后，经丙酮提取、盐析试剂包除水、石墨化炭黑除杂后，采用Agilent ZORBAX 300SB-C8液相色谱柱（2.1 mm×100 mm，1.8 μm）分离，甲醇-水程序洗脱，ESI雾化，串联质谱MRM检测。结果发现，该方法在0.0025~0.0500 mg/L范围内线性良好，决定系数r²=0.9996，定量检测限1.06 μg/L，回收率在90.8%~92.0%之间，相对标准偏差为5.1%。运用该方法测定烟草中的噁霉灵，操作简单，检测精度高，满足CORESTA对烟草农残检测的要求。     

TG-FTIR and Py-GC/MS study of the pyrolysis mechanism and composition of volatiles from flash pyrolysis of PVC

To facilitate the reuse and recycling of polyvinyl chloride (PVC) to achieve sustainable development and new industrialization, the composition and mechanism of formation of volatiles during the flash pyrolysis of PVC were studied by thermogravimetry-Fourier transform infrared (TG-FTIR) and pyrolysis-gas chromatography/mass spectrometry (Py-GC/MS). TG and derivative thermogravimetry (DTG) analyses indicated two main degradation stages during flash pyrolysis of PVC, namely dehydrochlorination of PVC and decomposition of dechlorinated-PVC. Simultaneously, the FTIR results revealed that the main functional groups in the pyrolysis process were H–Cl, -C-Cl, C–H, CH, and aromatic groups. The relative content of main volatiles was determined by Py-GC/MS, and decreased in the following order: aromatics > alkenes > hydrogen chloride (HCl) > chlorinated hydrocarbons. Specifically, the relative content of aromatics was as high as 76.790–81.809%, while that of HCl was in the range of 3.016–3.096%. The carbon number distribution and the relative content of main products obtained from the flash pyrolysis of PVC at different final temperatures were also analysed. According to the experimental results, the mechanism of formation of the main volatiles based on free-radical reactions was deduced in detail. Therefore, this study provides further details for deepening the understanding of the PVC pyrolysis process.